Address:Shandong province Qingdao city Jiaozhou Beiguan Industrial Park, Shandong Road No. 36
Tel:0532-87286912
Fax:0532-87286913
Mobile:13708952663
ZipCode:266300
WebSite:http://www.htffbw.com
E-mail：[email protected]
Application of hydraulic foaming platform equipment: thermal insulation pipeline, steam pipeline, heat pipe network. Special auxiliary equipment for producing polyurethane foam plastic heat insulating pipe by two steps foaming platform.
Application of hydraulic foaming platform equipment: thermal insulation pipeline, steam pipeline, heat pipe network. Special auxiliary equipment for producing polyurethane foam plastic heat insulating pipe by two steps foaming platform. Foaming platform using hydraulic mechanism for placement on the countertop appliances to be foamed pipe (safe middle bracket and an outer sleeve tube) at both ends of the rapid foaming mating flanges, location, close to ban, for foaming production.
The device has the characteristics of high efficiency, low energy consumption and easy operation, and greatly reduces the labor intensity of the operator. The machine is made up of the left and right flanges, motion system, working table, hydraulic and control system.
1, the flange adjustment movement system: the foam platform at both ends of the oil cylinder to push the flange of a push plate, the support wheel and guide rod with positioning in order to make the movement stable. The push plate is provided with a groove (hole) which can be installed on the foaming flange of each type, and the flange is positioned at the center of the push plate to prevent the inclination of the force. The seat plate of the push plate guide rod and the oil cylinder is positioned on both sides of the vertical guide groove, and the workpiece is used to replace the workpiece with different specifications to adjust the height of the center of the push plate. (the hand wheel for load adjustment, the adjustment should be the push plate is located near the position of the screw handwheel) work adjustment push plate flange and concentric and adjust the corresponding supporting wheel to push plate is kept in a vertical state, to reduce the resistance to motion.
2, work table: table for the steel plate and shape steel welded structure, divided into two sections, the strength is big, the rigidity is good. At both ends of each have two adjustable positioning block, in order to adjust the working level and push plate flange concentric. The bottom of the working table is provided with a lifting mechanism which can change the working table inclination angle. Adjust the angle of foaming (such as dip for more than 5 degrees can be dug pit in the adjustment angle adjustable pivot end).
3, hydraulic control system: the two ends of the push plate each have a HSGL-6345E head round flange connection, single Earrings type cylinder drive, the oil cylinder thrust 49.88kN (5T). The bottom lift oil cylinder is two HSGL-8045 type, each oil cylinder thrust is 80.42kN (8T). The working pressure of the hydraulic system is 16MPa, when the pressure gauge shows the pressure is not normal, the relief valve should be adjusted accordingly. The motion of each cylinder is controlled by 3 manual reversing valve
